Genie 1022 User Manual download pdf (Page 9)

PN# 3642036212, 8/09/2007

OPERATOR ASSEMBLY

FOR HELP-1.800.354.3643 OR WWW.GENIECOMPANY.COM

NOTE: Three (3) piece rail assemblies are for a 7

foot high door.

Clear a workspace area to unpack and organize box

and contents for assembly.

1. There are 4 boxes inside the carton. Each box is

numbered 1 - 4. Note that some operators will

contain the same parts and be packaged with

fewer boxes. Carefully remove the three

internal boxes (Labeled #1, 2, and 3) and place

them on the floor for easy access. (Fig. 1-1).

These boxes contain assembly parts and the

contents are organized by assembly tasks. For

quick reference inside the lid of each box there is

a label illustrating the components inside.

2. Remove the motor power head and place it on

the floor for later use. Remove box #4 and

place it on the floor for later use.

NOTE: For 1-piece rail—skip to POWER HEAD &

RAIL ASSEMBLY on the next page.

Do NOT run until operator is fully assembled.

CAUTION

FIG. 1-1 Internal boxes.

RAIL ASSEMBLY: Use a clean, flat surface.

Rail Connectors

Rail Connector Bolts

Rail Connector Nuts

rac

ctu

r fo

ING

TEN

use

rio

s I

ry or De

Bolts

Power head

Rail

Mounting

Straps

Lag Srews

5/16" Nuts

& Bolts

Header Bracket

Bolts

Header Bracket

Bag 2

Bag 3Bag 1

Bag 0

Box Label Example

READ AND FOLLOW ALL SAFETY, INSTALL ATION

AND OPERATION INSTRUCTIONS.

(If you have

questions or do not understand an instruction, call The

Genie Company or an authorized Genie Dealer.)

2. Install only on a properly balanced sectional garage door.

An improperly balanced door could cause severe injury.

Have a professionally trained service technician make

repairs to cables, spring assemblies, and other hardware

before installing the opener.

3. Remove all ropes and remove or make inoperative all

locks connected to the garage door before installing opener.

4. Where possible, install the door opener 7 feet or more

above the floor. For products having an emergency

release, mount the emergency release 6 feet above the floor.

IMPORTANT INSTALLATION INSTRUCTIONS

WARNING:

To reduce the risk of severe injury or death:

5. Do NOT connect the operator to source of power

until instructed to do so.

6. Locate the control button:

• Within sight of door,

• At minimum height of 5 feet so small children are not

able to reach it, and

• Away from all moving parts of the door.

7. Install the Entrapment WARNING Label next to the

control button in a prominent location. Install the

Emergency Release Marking on or next to the

emergency release.

8. After installing the opener, the door must reverse when

it contacts a 1-1/2 inch high object (or a 2 x 4 board laid

flat) on the floor.

To reduce the risk of injury to persons or

damage to property - Use this operator only

with sectional doors.

WARNING

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments

Genie 1022 User Manual Page 9

Comments to this Manuals

Related products and manuals for Kitchen Genie 1022