Genie 1022 User Manual download pdf (Page 20)

PN# 3642036212, 8/09/2007

FIG. 6-5 2 x 4 under center of door opening.

CONTACT REVERSE TEST

The force adjustments and limit switch settings

MUST BE COMPLETED before testing.

1. Testing.

• Open garage door using wall control.

– Place a 2" x 4" board (laid flat) under center

of garage door opening (Fig. 6-5).

• Close door using wall control.

• When door contacts board, it must stop and

reverse (within 2 seconds) to open position.

2. Adjustment.

• If the door does not properly reverse.

– Check to see if door has "close" limit

programmed. It should not have reached its

"close" limit before hitting board.

– If the door STOPS but does not reverse,

decrease "CLOSE FORCE" control

setting slightly (turn it counter-clockwise).

• Test again. Repeat as necessary.

1. Press and hold both of the "SET" buttons

( & ) together until the green indicator

light blinks (about 5 seconds).

2. All close and open travel limit settings are

erased. Then follow the steps above to

reprogram close and open travel limits.

NOTE: The operator will not close the door

automatically unless the Safety Beam System

is installed.

SET

1. By turning the Down Force Control clockwise,

the DOWN force can be increased. By turning

the Down Force Control counter-clockwise,

the DOWN force can be decreased. Set the

DOWN force level at the minimum force required

to close door without reversing.

2. Once the desired level is selected, this stores the

maximum force level for the DOWN direction in memory.

3. By turning the Up Force Control clockwise, the

UP force can be increased. By turning the Up Force

Control counter-clockwise, the UP force can be

decreased. Set the UP force level at the minimum

force required to open door without stopping.

4. Once the desired level is selected, this stores

the maximum force level for the UP direction

in memory.

OPEN

UP/DOWN FORCE

ERASE - OPEN/CLOSE TRAVEL LIMIT

OPEN

FORCE

Down Force

Control

Adjustment

Up Force

Control

Adjustment

ROTATE

CLOCKWISE

ROTATE

COUNTER-CLOCKWISE

FIG. 6-4 Force Control Adjustment.

UNLOCK

DOOR

LOCK

TO RECONNECT

PULL TOWARD

DOOR

TO RELEASE

PULL TOWARD

THE OPENER

FIG. 6-3 Engage/Disengage Carriage Lock.

CARRIAGE LOCK

The Carriage Lock can be manually engaged or

disengaged.

• To disengage Carriage Lock

– Pull handle towards opener.

• To engage Carriage Lock

– Pull handle towards door.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Genie 1022 User Manual Page 20

Comments to this Manuals

Related products and manuals for Kitchen Genie 1022