Genie 1022 User Manual download pdf (Page 22)

PN# 3642036212, 8/09/2007

22

REMOTE CONTROL

BATTERY REPLACEMENT AND VISOR CLIP INSTALLATION

8

FIG. 8-1 Open battery cover.

1. Battery replacement.

• Use coin, ball-point pen or similar device.

– Gently push straight in on battery cover lock

tab as shown (Fig. 8-1).

• Flip open battery cover.

– Remove old battery.

• Make sure new battery is facing proper direction

(Match battery polarity with symbols inside

battery cover) (Fig. 8-2).

– Recommended replacement battery type:

Alkaline A23, 12 volt.

• Slip new battery into place.

– Snap battery cover shut.

• Operate remote to make sure it is working

properly. (No re-programming is needed.)

2. Visor clip.

You will have to install the visor clip if you

choose to carry your remote attached to the car

visor.

• Slide visor clip into back of remote control.

– It will snap into place (Fig. 8-3).

FIG. 8-3 Attach visor clip.

FIG. 8-2 Match battery polarity.

LIGHT BULB/ LENS INSTALLATION

9

FIG. 9-2 Fasten lens.

NOTE: For lens cover locate Box 4.

1. Light bulb.

• Recommendations.

– Do NOT use a short neck bulb.

– Light bulb should be no more than 60 Watts.

– Use a heavy duty service bulb for longer life.

• Screw bulb into socket.

2. Lens.

• Select the white (lamp) cover. Do NOT use the

colored cover in this location.

• Line up lamp lens tabs on power head with

corresponding slots in lens (Fig. 9-1).

• Slide lens onto power head. Make sure the tabs

are fully engaged into lens slots (Fig. 9-2).

• Plug power cord back into electrical outlet.

– and + polarity marks

FIG. 9-1 Slide lens onto motor cover.

Lens tabs

Light bulb

Slide out

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments