Genie AWP 114002 User Manual download pdf (Page 18)

Operator’s Manual Third Edition • Fourth Printing

16 Genie AWP Super Series Part No. 114002

FUNCTION TESTS

Function Tests

Setup

1 Position the machine on a firm surface directly

below the desired work area.

2 Connect to the appropriate power source:

DC models: Connect the battery pack.

AC models: Connect to a grounded 15A AC

power supply. Use a 12 gauge / 3.3mm

2

3-wire

grounded extension cord no longer than

50 feet / 13 m.

Air models: Connect the air line.

3 Insert the key and turn to platform control.

4 Pull out the red Emergency Stop button to the

on position at the ground controls.

5 Twist to release the red Emergency Stop button

at the platform controls.

Result: AC & DC models: The power light should

come on.

Air models: The air pressure gauge should read

80-110 psi /5.5 - 7.8 bar.

6 Select an outrigger and

slide it into a base

socket until the

outrigger lock pin snaps

into place. Adjust the

outrigger to level the

machine and raise the

base casters slightly off

the ground. Level the

machine using only the

outriggers.

7 Check the interlock display

lights at the ground

controls. Confirm that the

corresponding light is on.

8 Repeat this procedure for each of the remaining

outriggers.

9 Use the bubble level and adjust the leveling

jacks until the machine base is level.

Test Emergency Stop

10 Push in the red Emergency Stop button at the

ground controls to the off position.

11 Push in the control activate button and rotate

the up/down switch in the direction of intended

travel.

Result: The up/down function should not

operate.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Comments to this Manuals

No comments