Genie Excelerator User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
^ CAUTION
Staples which are too tight may cut or pinch Wires. Cut or
pinched Wires can cause the Safe-T-Beam® System to stop
working. When installing the Insulated Staples, make sure
you fasten them only as tightly as needed to hold the
Wire securely.
Install Safe-T-Beam® Wiring (Figure 28):
Route Wire and Insulated Staples
(Figure 29 and Figure 30).
- Securely fasten Wires with Insulated Staples as
you go. Staples should be snug only.
- Wires between garage wall and Power Head should
be run on top of Rail and underneath Wire Clips.
Attach Wires to Safe-T-Beam® Sensors.
- Split and strip Wire ends to be connected as shown.
- Loosen Terminal Screws.
- Insert each Wire under flat plate and tighten Screw.
It does not matter which Wire, white or striped, goes
on which Terminal.
Attach Wires at Power Head.
- Wires are connected to Terminals #2 and #3 on
Power Head Terminal Block. It does not matter which
Wire, white or striped, goes on which Terminal.
Check the following.
- Ensure that no part of door or its hardware is in path
between Source or Sensor Lenses.
Ensure that tops of Lenses are between 5" - 6" above
floor. Brackets are flexible and can be adjusted slightly
if needed.
NOTE
The Safe-T-Beam® alignment check will be performed
following connection to electrical power.
Do Not plug in yet!
Wire Clips
Insulated
Staples
1(38)
) B /[
i iji)pjpi|i|ejfl| 11
■) ! i r
\ \l ! STB I 1/ /
' Terminal '
attachments
at Power Head
Terminal i
- attachments " . . ,
at Safe-T-Beam® Leave slack for
adjustment
//
¡ÎÎ s
0
Figure 29 Wiring Method A
Wire Clips 0
Insulated
Staples
.
.....
(Ss)
• M S’
Leave slack for
adjustment
Terminal '
attachments
at Power Head
Figure 30 Wiring Method A
FcM' Help, call 1-800HJS4SEiiE or visit svswi.ferileccirnpiirif.corn
17
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Comments to this Manuals

No comments