Genie Excelerator User Manual download pdf (Page 15)

For stictiorial cii3ors:

A Attach Curved Door Arm to Door Bracket with Clevis Pin and

Cotter Pin (Figure 23).

B Attach Straight Door Arm to Magnetic Carriage Assembly.

C Attach both Arms together with 2 (3/8" x 7/8") Hex Head

Bolts and 2 (3/8") Serrated Flange Hex Serial Number

Nuts so overall length is as short as pos

sible. Securely tighten fasteners.

D Adjust height of Emergency Release Cord Knob to 6' above

floor:

• Pull Cord through Magnetic Carriage Assembly Lever

until Knob is 6' from floor.

• Tie a new overhand knot in Cord at Magnetic Carriage

Assembly Lever.

Clevis Pins Cotter Pins

Safe-T-Beam® (STB) Brackets

#10-16 X 11/4"

Phillips Hex Head Screw

3/8"X 7/8"

Hex Head Bolts

3/8" Hex Serrated

Flange Nuts

Hardware (yellow bag)

For one-piece cli3cirs:

A Attach Straight Arm to Door Bracket with Clevis Pin and

Cotter Pin (Figure 24).

B Attach Curved Arm to Magnetic Carriage Assembly.

C Attach both Arms together with 2 (3/8" x 7/8") Hex Head

Bolts and 2 (3/8") Serrated Flange Hex Nuts so overall length

is as long as possible. Securely tighten fasteners.

D Adjust height of Emergency Release Cord Knob to 6' above

floor:

• Pull Cord through Magnetic Carriage Assembly Lever

until Knob is 6' from floor.

• Tie a new overhand knot in Cord at Magnetic Carriage

Assembly Lever.

A WARNING

Do Not skip Step D above!

Failure to comply may leave Emergency Release Knob within

reach of children. If the Knob is pulled with garage door fully

or partially open, garage door may close without warning!

As short as

possible

^ Curved

^(3^ @Door Arm

Figure 24 Assemble Arms (ONE-PIECE)

FcM' Help, call 1-800CJS4SEÌÌE or visit svswi.ferileccirnpiirif.corn

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments

Genie Excelerator User Manual Page 15

Comments to this Manuals

Related products and manuals for For the car Genie Excelerator