Genie Excelerator User Manual download pdf (Page 22)

A To program one Button of a Remote Control (Figure 37):

• Locate Learn Button and Learn Indicator Light near

Terminal Block on Power Head (Figure 38).

• Press and release Learn Button. Red Learn Indicator Light

will blink 2 times per second.

• Press Remote Control Button once within 30 seconds.

Red Learn Indicator Light will stay lit.

• Press Remote Control Button again. Red Learn Indicator

Light will go out, indicating that memory is stored.

B Program each additional Remote using step A above.

To Erase All ieiricites froiri Power H<?aci Memory

A Press and hold Learn Button on Power Head for 10 seconds or

until Learn Indicator Light goes out. Memory is erased:

• Program Remotes again as needed.

To ieplacts ierriote Control iattery

A Push in on Battery Cover Latch at base of Remote Control

(Figure 39):

• Use coin, pen, screwdriver or any similar device.

- Cover snaps open.

• Replace old Battery with new ^EVEREAD% A23,

12 Volt Battery.

B Snap Battery Cover closed.

A WARNING

A moving garage door may cause serious injury or death.

• Keep people clear of opening while door is moving.

• Do not allow children to play with the Remote Controls.

If the Safety Reverse does not work properly:

• Close the door and disconnect the Opener using the

Emergency Release Cord.

• Do not use the door Opener, Remote Controls, or

Wireless Keypad.

• Refer to the door and door Opener Owner's Manuals

before attempting any repairs.

Press Button on Remote Control. Garage door will move.

Press Button again. Garage door will stop:

• The door automatically stops at the end of the open or

close cycle.

Press Button again. Garage door will reverse.

NOTE

Each Remote Control must be programmed

separately.

The Remote Controls will not cause the door

Opener to close the garage door if the Safe-T-

Beam® System is malfunctioning.

When programming the Remote Controls, they

must be at least 24'Arom the Antenna Wire.

If the red Learn Indicator Light blinks

approximately 4 times per second,

programming has stopped. If programming

has stopped, repeat the above steps.

Each Button on a 2 or 3 Button Remote Control

is for a different Opener. You cannot use more

than one Button per Remote, per Opener.

A maximum of seven Remote Controls or

Wireless Keypads can be stored into the

Receiver at one time. If a Remote Control

becomes lost, or if you want to delete a Remote

Control or Wireless Keypad, see "To Erase All

Receiver Memory."

1 Button

Remote

2 Button

Remote

3 Button

Remote

Figure 37 Genie Remote Controls

Figure 38 Learn Code Button and Indicator Light

...

Visor Clip

Push to open

Battery Cover

Model

Number

iiJO'

Figure 39 Remote Control Battery Replacement

FcM' Help, call 1-SOOHJS4SEÌÌE or visit www.gBmstompsmi.mm

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comments to this Manuals

No comments

Genie Excelerator User Manual Page 22

Comments to this Manuals

Related products and manuals for For the car Genie Excelerator