Genie QuietLift 3563435770 User Manual download pdf (Page 9)

or H

elp

all 1-800-35-GENIE or visit www

.geniecompany.com

NOTE

• Each Remote Control must be programmed separately.

• The Remote Controls will not cause the door Opener to close

the garage door if the Safe-T-Beam® System is malfunctioning.

• When Programming the Remote Controls,they must be at

least 24”from the Antenna Wire.

• If the red Learn Indicator Light blinks approximately 4 times

per second,programming has stopped,repeat the above steps.

• Each Button on a 2 or 3 Button Remote Control is for a

different Opener.You cannot use more than one Button per

Remote,per Opener.

• A maximum of seven Remote Controls or Wireless Keypads

can be stored into the Receiver at one time.If a Remote

ol becomes lost,or if you want to delete a Remote

Control or Wireless keypad,see “To Erase all Receiver Memory”

Figure 3 Genie Remote Controls

1 Button

Remote

w/Flashlight

3 Button

Large

Remote

w/Flashlight

3 Button

Remote

w/Flashlight

Flashlight Button

Frequency

Switch

C Remote Control Operation.

• Press Button on Remote Control. Garage door will move.

• Press Button again. Garage door will stop:

The door automatically stops at the end of the open or

close cycle.

• Press Button again. Garage door will reverse.

• Some Remote Controls are equipped with a flashlight.The

enie logo is the button which operates the light.There is a

backlight under the button. When it does not light,it

indicates the battery needs replaced.

AND GO OUT

Figure 4 Erasing the remotes

E Replacing the batteries.

• Pop off the back of the transmitter using a coin.

•

Replace the battery with a new compatable coin

type battery.(size 2032)

• Snap the back of the transmitter on.

CAUTION

Should a remote become lost or stolen it is imperative that

the remote control codes be erased from the receiver

memory and new codes programmed,to prevent the

missing remote from being able to operate the door opener.

NOTE

If the light on the remote glows dimly or does not light

when operating the remote,replace the batteries.

D Erasing all remotes (Figure 4).

• Press and hold Learn Button on Power Head until Learn

Indicator Light goes out. Memory is erased.

• Program receiver again as needed.

Transmitter C

ompliance Statement

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Genie QuietLift 3563435770 User Manual Page 9

Comments to this Manuals

Related products and manuals for Kitchen Genie QuietLift 3563435770