Genie QuietLift 3563435770 User Manual download pdf (Page 5)

or H

elp

all 1-800-35-GENIE or visit www

.geniecompany.com

• Mark a point at center of door and on header directly

above door. Draw a center line to connect points.

B Find Header Bracket mounting height (Figure 4): (Do not attach

Header Bracket).

• Raise door,watching top edge of door and stop door

when its edge reaches its highest point.

• Measure distance (“H”) from top edge of door to floor.

– For sectional doors,add 1" to “H”. Mark a point

on center line. Bottom of Header Bracket will be

installed here.

– For one-piece doors,add 7" to “H”. Mark this point on

center line. Bottom of Header Bracket will be

installed here.

C Check wall for a stud or a solid header at your mark: (If checking a

finished wall,a stud finder may be helpful).

• If location is above Header,a 2" x 6" board must be

screwed to studs beside your mark with at least two Lag

Screws and Flat Washers (not provided).

• T

ansf

er y

our mar

k t

o new moun

ting b

oard.

NOTE

• For both types of doors:

– If the ceiling in your garage is so low that there

is not at least a 3" space above the Header

Bracket mounting point,contact a Genie Factory

Authorized Dealer.

• If a door spring is in the way,place the Header

Bracket above the spring.

Do Not move the door

spring.

Figure 4 Find Highest Point of Travel

SECTIONAL DOOR

ONE-PIECE DOOR

HEADER

CHECK DOOR HEADER AREA

A Find vertical center line of door and header:

• Close door.

• Measure door width at top.

Check Step 4:

NOTE

The header is a heavily reinforced section of the wall just

above the top of the garage door opening.

CHECK POWER HEAD

MOUNTING AREA

heck ceiling or space above where Opener Power Head will be

mounted (

Figure 5):

A Measure from garage door center line toward rear of garage:

• Approximately 11'.

B Find location of ceiling joist or truss above where Opener Power

Head will be and estimate type and quantity of materials needed for

your installation (Figure 6).

Check Step 5:

120 Volt grounded outlet

or wiring box within 3 feet of

Power Head.

Door Center Line

Figure 5 Check Power Head location

11'

Conduit

Perforated Angle Iron

igur

e 6

oun

ting metho

ds f

or op

en b

eam or finished c

eilings

FINISHED CEILINGS

Locate ceiling joists or trusses using

a stud finder or similar device.

Attach angle iron(not included) to

joists or trusses through finish

material using Lag Screws.

OPEN CEILINGS Straps and angle

iron may attach directly to joists

or trusses.

MOUNTING EXAMPLES

55 11

erforated Straps

1 2 3 4 5 6 7 8 9 10 ... 15 16

Comments to this Manuals

No comments

Genie QuietLift 3563435770 User Manual Page 5

Comments to this Manuals

Related products and manuals for Kitchen Genie QuietLift 3563435770