Genie QuietLift 3563435770 User Manual download pdf (Page 7)

or H

elp

all 1-800-35-GENIE or visit www

.geniecompany.com

ALIGNING THE SAFETY-T-BEAMS®

Figure 1 SAFE-T-Beam®

igur

e 2

Indic

or Ligh

NOTE

The Safe-T-Beam® is an invisible ray of light that travels

across the bottom of the garage door opening (

Figure 1).If

an object blocks the beam while the garage door is closing,

the opener will stop,then reverse and fully open the door.

MAINTENANCE AND ADJUSTMENTS

Step 1:

WARNING

THE SAFE-T-BEAM® MUST BE ALIGNED OR THE OPEN-

ER WILL NOT FULLY FUNCTION.

Serious injury or death from a closing garage door may

result because of failure to test the safety reverse system.

Repeat this test monthly and adjust as needed.

NOTE

The Safe-T-Beam® indicator lights display the status of

the Safe-T-Beam® system (

Figure 2).

A A

djusting the beam (

igure 3

)

• Adjust the source and sensor units until the Green

indicator lights stay on.

–

Be sure to stay out of the path of the beam while

aking adjustments.

• If one Green indicator light stays off,check for

– Dirt on the lens.

– Sun shinning into the lens.

–

A short in the wiring (check staples and

onnections at terminals).

Figure 3 Adjusting Beam

Source Red LED

ON = Power On

OFF= Power Off

If OFF,check wire con-

nection at Powerhead.

Check for broken or

shorted wires.Check

for def

ective source.

Sensor Green (2 LED’s)

BOTH OFF = NoPower

ONE OFF / ONE ON=Misaligned.

ONE ON / ONE BLINKING=Beam

needs better alignment.

BOTH ON = Normal Function,

No Obstruction.

Receiver

Sensor

Transmitter

Source

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Genie QuietLift 3563435770 User Manual Page 7

Comments to this Manuals

Related products and manuals for Kitchen Genie QuietLift 3563435770