Genie Z-34 User Manual Page 5

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 4
Operator's Manual
Fourth Edition • Third Printing
Part No. 1000048 Z-34/22 IC 3
CE and Australia Markets: Do not use air-filled
tires. These machines are equipped with
foam-filled tires. Wheel weight and proper
counterweight configuration are critical to
stability.
Do not drive over 0.6 mph / 1 km/h with the
primary boom raised or extended or the
secondary boom raised.
Do not raise the boom when wind speeds may
exceed 28 mph / 12.5 m/s. If wind speeds exceed
28 mph / 12.5 m/s when the boom is raised, lower
the boom and do not continue to operate the
machine.
Do not operate the machine in strong or gusty
winds. Do not increase the surface area of the
platform or the load. Increasing the area exposed
to the wind will decrease machine stability.
Use extreme care and slow speeds while driving
the machine in stowed position across uneven
terrain, debris, unstable or slippery surfaces and
near holes and drop-offs.
Do not drive the machine on or near uneven
terrain, unstable surfaces or other hazardous
conditions with the boom raised or extended.
Do not drive the machine on a slope that exceeds
the maximum uphill, downhill or side slope rating
of the machine. Slope rating applies only to
machines in the stowed position.
Maximum slope rating, stowed position, 2WD
Counterweight uphill 37% 20°
Counterweight downhill 20% 11°
Side slope 25% 14°
Maximum slope rating, stowed position, 4WD
Counterweight uphill 45% 24°
Counterweight downhill 40% 22°
Side slope 25% 14°
Note: Slope rating is subject to ground conditions
and adequate traction.
Do not push off or pull toward any object outside
of the platform.
Maximum allowable
side force - ANSI &
CSA
150 lbs / 667 N
Maximum allowable
manual force - CE
90 lbs / 400 N
Do not alter or disable machine components that
in any way affect safety and stability.
Do not replace items critical to machine stability
with items of different weight or specification.
SAFETY RULES
Page view 4
1 2 3 4 5 6 7 8 9 10 ... 39 40

Comments to this Manuals

No comments