8
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
NOTE
The door must contact the 2” x 4” board before the
Carriage activates the Close Limit Switch. If not, readjust
the Close Limit Switch.
Se t t i N G Co N t a C t Re V e R S e
fu N C t i o N
Adjustment 2:
NOTE
Limit Switch and Force Adjustments must be completed
before checking the contact reverse function (Figure A-3).
2” x 4” board
laid flat
Figure A-3 Checking Contact Reverse
A Open garage door using Wall Console.
B Lay a 2” x 4” board flat in center of doorway.
C Close door using Wall Console.
D Check that door stops and reverses
within 2 seconds after it
contacts board:
• If door does not reverse, decrease
Close Force until door reverses.
• If door still does not reverse, move
CLOSE Limit Switch toward door.
E Check Safe-T-Beam® System operation:
• If beam is blocked, door will
not close.
Transmitter Compliance Statement
A
To program one Button of a Remote Control (Figure MA-1):
• Locate Learn Button and Learn Indicator Light
on back side of Power Head under the Lens
(Figure MA-2).
• Press and release Learn Button. Red Learn
Indicator Light will blink 2 times per second.
• Press Remote Control Button once within 30
seconds. Red Learn Indicator Light will stay lit.
• Press Remote Control Button again. Red Learn
Indicator Light will go out, indicating that
memory is stored.
B
Program each additional Remote using step A above
(up to seven remotes).
NOTE
• Each Remote Control must be programmed
separately.
• The Remote Controls will not cause the door
Opener to close the garage door if the Safe-T-
Beam® System is malfunctioning.
• When programming the Remote Controls, they
must be at least 24” from the Antenna Wire.
• If the red Learn Indicator Light blinks
approximately 4 times per second,
programming has stopped. If programming
has stopped, repeat the above steps.
• Each Button on a 2 or 3 Button Remote Control
is for a different Opener. You cannot use more
than one Button per Remote, per Opener.
• A maximum of seven Remote Controls or
Wireless Keypads can be stored into the
Receiver at one time. If a Remote Control
becomes lost, or if you want to delete a Remote
Control or Wireless Keypad, see “To Erase All
Receiver Memory.”
C pR o G R a m m i N G t h e
R
e m o t e Co N t R o l S
Programming 1:
aC C e S S o R i e S
WARNING:
A moving garage door may cause serious injury or
death.
• Keep people clear of opening while door is moving.
• Do not allow children to play with the Remote
Controls.
If the Safety Reverse does not work properly:
• Close the door and disconnect the Opener using
the Emergency Release Cord.
• Do not use the door Opener, Remote Controls, or
Wireless Keypad.
• Refer to the door and door Opener Owner’s
Manuals before attempting any repairs.
(66 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals