Genie M-4700 User Manual download pdf (Page 15)

■ Locate position where top mounting screw will go. Mark

location on wall.

■ Drill 1/16" pilot hole into wall. (If mounting to drywall,

drill 3/16” pilot hole and use anchors provided).

■ Insert top screw into wall. DO NOT TIGHTEN FLUSH WITH

WALL. Leave screw head out approximately 1/8" from wall.

See Fig. 31–1 (Front).

■ Position wall control panel onto screw, and push down to

lock into place.

■ Mark hole location through bottom screw hole. Swing

wall control and drill second pilot hole.

■ Insert screw through bottom hole from the front, and

tighten screw to secure control to wall.

■ Make sure wiring is routed out from behind control

through one of the recessed cutouts to avoid pinching

the wires.

Doorbell-Type Pushbutton

Follow the same steps as above with one exception, mark

both mounting holes at same time, then drill and secure

unit to wall (in the case of the doorbell-type Pushbutton,

it does not matter which wire attaches to which terminal.

See Fig. 31–2.

■ Run wires from wall control panel and photo eye system

along wall and ceiling to opener powerhead. Use the sta-

ples that are provided to secure wiring to wall, joists and

ceiling. Do not pinch wiring. Drive staples with only

enough force to hold wiring in place. Refer to Fig. 9 on

p.7 for an example of typical wiring routing.

NOTE: As an alternative for photo eye system, the wiring

can be routed along the top of the rail, or along the out-

side of the door track. Be sure the wiring is routed away

from all moving parts of the door and rail.

■ Separate 2” of double wire from each photo eye into two

single wires. Strip about 1/2” of insulation from the end

of each of the four single wires. Combine the white wires

from each photo eye and twist stripped ends together

tightly. Do the same with color striped wires.

■ Open the control panel by slightly pulling on the panel

cover cutout, then allowing the cover to hang open.

■ Feed control panel and photo eye system wires through

wire guide from the top of the chassis into terminal area

of control panel.

■ Firmly insert white wire combination into terminal hole #1

by pushing directly into hole. Insert color striped wire

combination into terminal #2.

NOTE: If wires are difficult to insert, a screwdriver may be

used to depress the terminal “tab” while inserting the

wires. To remove wires, depress tab again and pull wires

out.

■ Insert white single wire from wall control into terminal #3

and single color striped wire into terminal #4.

NOTE: Multiple wall controls may be installed in parallel

with wires connected to terminals #3 and #4.

8-12. CONNECTING WIRES TO POWERHEAD

8-11. INSTALL WALL CONTROL PANEL

(cont’d)

Wire Guide

Chassis

Terminal Holes

Tab

Terminal Numbers

To Terminal 1

To Terminal 2

Wiring from Photo Eyes and Wall Control

To Terminal 3

To Terminal 4

Top Screw Protruding

from Wall

Back

Front

Terminals

Cutout

30’ Wire

To Terminal

#3 Screw

To Terminal

#4 Screw

Doorbell-Type

Pushbutton

2 Screws

Fig. 31

Fig. 32

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 31 32

Comments to this Manuals

No comments

Genie M-4700 User Manual Page 15

Comments to this Manuals

Related products and manuals for Garage Door Opener Genie M-4700