Genie S-85 User Manual download pdf (Page 19)

Part No. 43650 Genie S-80 & Genie S-85 17

Operator's ManualSecond Edition · Fifth Printing

FUNCTION TESTS

9 Hold the function enable switch to either side

and activate the boom extend function.

Result: The boom should extend no more than 6

inches (15 cm) and then stop. The boom should

not extend beyond the limit switch unless both

axles are extended.

10 Hold the function enable switch to either side

and activate the boom retract function.

Result: The boom should retract.

11 At the extendable axle controls, extend the jack.

Result: The jack should extend and raise the

machine.

12 Extend the axle.

Result: The axle should extend.

13 Retract the jack.

Result: The jack should retract and lower the

machine.

14 Repeat steps 11-13 for the other jack and axle.

15 Hold the function enable switch to either side

and activate the boom raise and lower function.

Result: The boom should raise and lower

normally.

16 Hold the function enable switch to either side

and activate the boom extend and retract

functions.

Result: The boom should extend and retract

normally.

Test the Machine Functions

17 Do not hold the function enable switch to either

side. Attempt to activate each boom and

platform function toggle switch.

Result: All boom and platform functions should

not operate.

18 Hold the function enable switch to either side

and activate each boom and platform function

toggle switch.

Result: All boom and platform functions should

operate through a full cycle. Descent alarm (if

equipped) should sound while boom is lowering.

Machines equipped with Platform Level Control

Disable Function: The platform level toggle switch

will not operate when the boom is raised or

extended past the drive speed limit switches.

Test the Tilt Sensor

19 Pull out the platform red Emergency Stop button

to the ON position. Turn the key switch to

platform control.

20 Open the tank side turntable

cover and locate the tilt sensor

next to the control box.

21 Press down one side of the tilt

sensor.

Result: The alarm, located in

the platform, should sound.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 32 33

Comments to this Manuals

No comments

Genie S-85 User Manual Page 19

Comments to this Manuals

Related products and manuals for For the car Genie S-85