Genie Z-22N User Manual download pdf (Page 19)

Part No. 43654 Genie Z-34/22 & Genie Z-34/22N 17

Operator's Manual

Second Edition • Ninth Printing

Test Limited Drive Speed

29 Move the lift/drive select switch to the lift

position (if equipped).

30 Press down the foot switch.

31 Raise the primary boom 1 foot / 30 cm.

32 Move the lift/drive select switch to the drive

position (if equipped).

33 Slowly move the drive control handle to the full

drive position.

Result: The maximum achievable drive speed

with the primary boom raised should not

exceed 1 foot / 30 cm per second.

34 Move the lift/drive select switch to the lift

position (if equipped).

35 Lower the boom to the stowed position.

36 Raise the secondary boom 1 foot / 30 cm.

37 Move the lift/drive select switch to the drive

position (if equipped).

38 Slowly move the drive control handle to the full

drive position.

Result: The maximum achievable drive speed

with the secondary boom raised should not

exceed 1 foot / 30 cm per second.

39 Move the lift/drive select switch to the lift

position (if equipped).

40 Lower the boom to the stowed position.

41 Extend the primary boom 1 foot / 30 cm.

42 Move the lift/drive select switch to the drive

position (if equipped).

43 Slowly move the drive control handle to the full

drive position.

Result: The maximum achievable drive speed

with the primary boom extended should not

exceed 1 foot / 30 cm per second.

If the drive speed with the primary boom raised or

extended or the secondary boom raised exceeds

1 foot / 30 cm per second, immediately tag and

remove the machine from service.

Test the Drive Enable System

44 Move the lift/drive select switch to the lift

position (if equipped).

45 Press down the foot switch and retract the

primary boom to the stowed position.

46 Rotate the turntable until the boom moves past

one of the non-steer wheels.

Result: The drive enable

indicator light should

come on and remain on

while the boom is

anywhere in the range

shown.

47 Move the lift/drive select switch to the drive

position (if equipped).

48 Move the drive control handle off center.

Result: The drive function should not operate.

49 Hold the drive enable toggle switch up or down

and slowly move the drive control handle off

center.

Result: The drive function should operate.

Note: When the drive enable system is in use, the

machine may drive in the opposite direction that the

drive and steer control handle is moved.

Use the color-coded direction

arrows on the platform controls

and the drive chassis to

identify the direction of travel.

FUNCTION TESTS

Blue

Yellow

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Comments to this Manuals

No comments

Genie Z-22N User Manual Page 19

Comments to this Manuals

Related products and manuals for Utility Vehicle Genie Z-22N