Genie TML-4000 User Manual download pdf (Page 20)

18 Genie TML-4000 and TML-4000N Part No. 97600

Operator's Manual Third Edition • Second Printing

OPERATING INSTRUCTIONS

To Raise the Mast

1 Unlock the mast hold-down latch.

2 Turn the Raise/Lower winch handle clockwise

until the mast reaches the full vertical position

and the front spring latch locks the mast firmly

in place.

To Extend the Mast

1 Turn the Extend/Retract winch handle clockwise

to extend the mast sections.

2 Approximately 6 inches / 15 cm below full mast

extension, the lamp fixture will begin to tilt. The

more the winch handle is turned, the greater the

tilt, until the mast is fully extended and the lights

are positioned.

Note: To adjust the lights after the mast is fully

extended, slowly lower the mast by turning the

winch handle counterclockwise until the lights are

in the desired position.

To Rotate the Mast

1 Press and hold the mast rotation lever and

rotate the mast to the desired position.

2 Release the lever.

To Stow the Mast

1 Press and hold the mast rotation lever and

rotate the mast to its original position. Line up

the black arrows on the front of the mast.

2 Turn the Extend/Retract winch handle

counterclockwise until the mast sections retract.

The mast is fully retracted when the blue arrows

on the side of the mast are lined up.

3 Pull and hold the mast release latch below the

control panel.

4 Turn the Raise/Lower winch handle

counterclockwise and lower the mast

completely into the transport cradle.

Note: If the mast has not been fully retracted, it will

not rest completely in the cradle.

5 Turn the mast hold-down latch handle

counterclockwise and push into the lock.

6 Turn the latch handle clockwise until the handle

points straight down. The latch should turn

freely without binding or hesitation.

Grounding Rod Attachment

A grounding rod attachment is located next to the

generator under the cover on the control panel side

of the machine.

After Each Use

1 Select a safe parking location—firm, level

surface, clear of obstructions and traffic.

2 Remove the key OR lock the control panel to

secure from unauthorized use.

To Store the Lamp Fixtures

(Standard models)

Note: Do not touch hot lamp fixtures. Make sure

the lights are turned off and the lamp fixtures have

cooled down before touching.

For each lamp fixture:

1 Disconnect the electrical plug and cap the

receptacle socket.

2 Remove the safety pins and release the

latches.

3 Pull the lamp fixture up and off the mounting

bracket.

4 Slide the lamp fixture onto the channels located

under the covers.

5 Close and secure the covers before transport.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 26 27 28

Comments to this Manuals

No comments

Genie TML-4000 User Manual Page 20

Comments to this Manuals