Genie TML-4000 User Manual download pdf (Page 14)

12 Genie TML-4000 and TML-4000N Part No. 97600

Operator's Manual Third Edition • Second Printing

MAINTENANCE

Scheduled Maintenance

Maintenance performed quarterly, annually and

every two years must be completed by a person

trained and qualified to perform maintenance on

this machine according to the procedures found in

the service manual for this machine.

Machines that have been out of service for more

than three months must receive the quarterly

inspection before they are put back into service.

Check the Tires and Wheels

Bodily injury hazard. An over-

inflated tire can explode and may

cause death or serious injury.

Collision hazard. An excessively

worn tire can cause poor handling

and continued use could result in

tire failure.

Tip-over hazard. Do not use

temporary flat tire repair products.

Maintaining the tires and wheels in good condition

is essential to safe operation and good

performance. Tire and/or wheel failure could result

in a machine tip-over. Component damage may

also result if problems are not discovered and

repaired in a timely fashion.

1 Check the tire surface and sidewalls for cuts,

cracks, punctures and uneven or excessive

tread wear. Replace the tire if uneven or

excessive tread wear is found.

2 Check each wheel for damage, bends and

cracks. Replace the wheel if any damage is

found.

Tires and wheels must be replaced

with tires and wheels of the

specifications listed.

3 Check each tire with an air pressure gauge and

add air as needed.

4 Check the torque of each lug nut.

Tires and wheels - Standard and Narrow models

Tire size ST185/80D13

Rim size 13 x 4.5 in 33 x 11.4 cm

Lug nut torque 80 ft-lbs 108 Nm

Tire pressure (cold) 50 psi 3.4 bar

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 27 28

Comments to this Manuals

No comments