Genie TZ-50 User Manual download pdf (Page 16)

14 Genie TZ-50 Part No. 114164

Operator's Manual Second Edition • First Printing

Check the Hydraulic Oil Level

Maintaining the hydraulic oil at the proper level is

essential to machine operation. Improper hydraulic

oil levels can damage hydraulic components. Daily

checks allow the inspector to identify changes in

oil level that might indicate the presence of

hydraulic system problems.

1 Be sure the boom is in the stowed position and

the outriggers are raised.

2 Open the cover on the side of the machine

opposite the ground controls.

3 Use the marks on the side of the hydraulic tank

to determine the level of hydraulic oil.

Result: The hydraulic oil level should be

between the ADD and FULL marks.

4 Add hydraulic oil if necessary.

Hydraulic oil specifications

Hydraulic oil type Chevron Rykon

Premium MV equivalent

MAINTENANCE

Check the Tires and Wheels

Bodily injury hazard. An over-

inflated tire can explode and may

cause death or serious injury.

Collision hazard. An excessively

worn tire can cause poor handling

and continued use could result in

tire failure.

Tip-over hazard. Do not use

temporary flat tire repair products.

Maintaining the tires and wheels in good condition

is essential to safe operation and good

performance. Tire and/or wheel failure could result

in a machine tip-over. Component damage may

also result if problems are not discovered and

repaired in a timely fashion.

1 Check the tire surface and sidewalls for cuts,

cracks, punctures and uneven or excessive

tread wear.

Result: Replace the tire if uneven or excessive

tread wear is found.

Tires and wheels must be

replaced with tires and wheels of

the specifications listed.

2 Check each wheel for damage, bends and

cracks.

Result: Replace the wheel if any damage is

found.

3 Check each tire with an air pressure gauge and

add air as needed.

4 Check the torque of each lug nut.

Tires and wheels - ANSI, CSA and Australia

Tire size 225/75 R15

Load Range D

Lug nut torque (dry) 80 ft-lbs 108 Nm

Tire pressure (cold) 65 psi 4.5 bar

Tires and wheels - CE

Tire size 215/70 R14

Load Range C

Lug nut torque (dry) 192 ft-lbs 260 Nm

Tire pressure (cold) 65 psi 4.5 bar

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 40 41

Comments to this Manuals

No comments

Genie TZ-50 User Manual Page 16

Comments to this Manuals

Related products and manuals for Tools Genie TZ-50