Genie TZ-50 User Manual download pdf (Page 24)

22 Genie TZ-50 Part No. 82900

Operator's Manual First Edition • Sixth Printing

OPERATING INSTRUCTIONS

Operation from Platform

1 Turn the key switch to platform control.

2 Pull out both ground and platform red

Emergency Stop buttons to the on position.

To Position Platform

1 Push and hold the appropriate function enable

button.

2 Push and hold the coordinating boom function

button according to the markings on the control

panel.

Starting the Engine (if equipped)

The machine can be operated with or without the

engine running.

1 At the ground controls, turn the key switch to

the desired position.

2 Be sure both ground and platform control red

Emergency Stop buttons are pulled out to the

on position.

3 Be sure the key switch on the

engine is turned to the ON position.

4 Press the engine start button.

If the engine fails to start after 15

seconds of cranking, determine the

cause and repair any malfunction. Wait

60 seconds before trying to start again.

In cold conditions, hold the choke

button and then start the engine.

Setup for Operation

1 Position the machine below the desired work

area.

2 Set the parking brake.

3 Disconnect the trailer lights, safety chains and

brake cables from the vehicle.

4 Open the latch on the ball coupler.

5 Pull the jack release handle and rotate the

tongue jack to the lifting position.

6 Raise the tongue by turning the jack handle.

7 Be sure the boom hold-down latches are

unlatched.

8 Be sure the batteries are connected.

Operation from Ground

1 Turn the key switch to ground control.

2 Pull out the red Emergency Stop button to

the on position.

3 Press and hold the yellow function

enable button. Press and hold the

auto level button or the individual

outrigger buttons to lower the

outriggers and level the machine.

4 Check the bubble level to make sure the

machine is level.

To Position Platform

1 Push and hold the appropriate function enable

button.

2 Push and hold the boom function buttons

according to the markings on the control panel.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 38 39

Comments to this Manuals

No comments