Genie Model 2022 User Manual download pdf (Page 22)

PN# 37026500123 02/26/2010 REV. 1

FIG. 6-6 2 x 4 under center of door opening.

CONTACT REVERSE TEST

The force adjustments and limit switch settings

MUST BE COMPLETED before testing.

1. Testing.

• Open garage door using Wall Control.

– Place a 2" x 4" board (laid flat) under center

of garage door opening (FIG. 6-6).

• Close door using Wall Control.

• When door contacts board, the door must stop

(within 2 seconds) and reverse direction

returning to open position.

2. Adjustment.

• If the door does not properly reverse.

– Check to see if door has "close" limit

programmed. It should not have reached its

"close" limit before hitting board.

– If the door STOPS but does not reverse,

decrease "CLOSE FORCE" control

setting slightly (turn it counter-clockwise).

• Test again. Repeat as necessary until door

reverses upon contacting board.

1. Press and hold both of the "SET" buttons

( & ) together until the green indicator

light blinks (about 5 seconds).

2. All close and open travel limit settings are

erased. Then follow the steps above to

reprogram close and open travel limits.

NOTE: The opener will not close the door

automatically unless the Safe-T

-Beam

System is

installed.

SET

ERASE - OPEN/CLOSE TRAVEL LIMIT

1. By turning the "Close Force Control" clock-

wise, the DOWN force can be increased. By

turning the "Close Force Control" counter-

clockwise, the DOWN force can be decreased.

Set the DOWN force level at the minimum force

required to close door without reversing.

2. Once the desired level is selected, this stores the

necessary force level for the DOWN direction in memory.

3. By turning the "Open Force Control" clockwise,

the UP force can be increased. By turning the

"Open Force Control" counter-clockwise, the UP

force can be decreased. Set the UP force level at

the minimum force required to open door without

stopping.

4. Once the desired level is selected, this stores

the necessary force level for the UP direction

in memory.

OPEN

UP/DOWN FORCE

OPEN

FORCE

Down Force

Control

Adjustment

Up Force

Control

Adjustment

ROTATE

CLOCKWISE

ROTATE

COUNTER-CLOCKWISE

(Increasing Force)

(Decreasing Force)

FIG. 6-5 Force Control Adjustment.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 28 29 30

Comments to this Manuals

No comments

Genie Model 2022 User Manual Page 22

Comments to this Manuals