Genie TMZ-10 User Manual download pdf (Page 23)

Part No. 72896 Genie TMZ-50/30 & Genie TMZ-17/10 21

Operator's Manual

First Edition • Third Printing

Emergency Stop

Push in the red Emergency Stop button to the OFF

position to stop all ground and platform control

functions.

Repair any function that operates from the ground

or platform controls when the Emergency Stop

button at the ground controls is pushed in.

Repair any function that operates from the platform

when the Emergency Stop button at the platform

controls is pushed in.

Set up

1 Position the machine directly below the desired

work area.

2 Set the parking brake.

3 Disconnect the trailer lights, chains and surge

brake safety cable from the vehicle.

4 Open the latch on the ball coupler.

5 Pull the jack release handle and rotate the

tongue jack to the lifting position.

6 Raise the tongue by turning the jack handle.

7 Open all boom hold-down latches.

8 Push and hold the auto-level button. Push and

hold the extend outrigger button. The outriggers

will lower and adjust to level the machine and

raise the wheels slightly off the ground.

9 Be sure that all four interlock display lights are

on at the ground control panel.

Operating Instructions

Do Not Operate Unless:

You learn and practice the principles of safe

machine operation contained in this operator's

manual.

1 Avoid hazardous situations.

2 Always perform a pre-operation

inspection.

3 Always perform function tests prior to use.

4 Inspect the workplace.

5 Only use the machine as it was intended.

Fundamentals

The Operating Instructions section provides

instructions for each aspect of machine operation.

It is the operator's responsibility to follow all the

safety rules and instructions in the operator's,

safety and responsibilities manuals.

Using the machine for anything other than lifting

personnel and tools to an aerial work site is unsafe

and dangerous.

Only trained and authorized personnel should be

permitted to operate a machine. If more than one

operator is expected to use a machine at different

times in the same work shift, they must all be

qualified operators and are all expected to follow all

safety rules and instructions in the operator's,

safety and responsibilities manuals. That means

every new operator should perform a pre-operation

inspection, function tests, and a workplace

inspection before using the machine.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 33 34

Comments to this Manuals

No comments

Genie TMZ-10 User Manual Page 23

Comments to this Manuals