Genie TMZ-10 User Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 34
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19
18 Genie TMZ-50/30 & Genie TMZ-17/10 Part No. 72896
Operator's Manual First Edition • Third Printing
FUNCTION TESTS
Test the Boom Functions
16 Do not hold a function enable/speed select
button. Attempt to activate each boom function
button.
Result: All boom functions should not operate.
17 Press and hold a function enable/speed select
button. Activate each boom function button.
Result: All boom functions should operate
through a full cycle.
Test the Tilt Sensor
18 Raise the jib boom approximately 6 inches /
15 cm. Raise the primary boom approximately
6 inches / 15 cm off the boom rest. Raise the
secondary boom approximately 6 inches /
15 cm off the boom rest. Extend the primary
boom approximately 12 inches / 30 cm.
19 Locate the tilt sensor on
the chassis near the
ground controls.
20 Press down one side of the
tilt sensor and place the tilt
sensor test tool under one
of the posts.
Result: The alarm, located in the platform,
should sound after 1 second.
The interlock display light should flash.
21 Test all ground and platform control functions.
Result: The primary boom up, the secondary
boom up, the jib boom up and the primary
extend functions should not operate. The
primary boom down, the secondary boom
down, the jib boom down, the primary boom
retract and the rotate functions should operate
normally.
22 Remove the tilt sensor test tool.
7 Check the interlock display. Be sure that all four
interlock display lights are on.
8 Start the engine (if equipped). See Operating
Instructions section.
At the Ground Controls
Test Emergency Stop
9 Push in the red Emergency Stop button to the
OFF position.
Result: The engine (if equipped) should turn off.
All ground and platform control functions should
not operate.
10 Pull out the red Emergency Stop button to
the ON position.
Test Outrigger Interlock
11 Start the engine (if equipped).
12 Push and hold an outrigger button and push
and hold the retract outrigger button to raise
one outrigger until the corresponding interlock
display light turns off.
13 Activate the boom functions.
Result: Boom functions should not operate.
14 Push and hold the auto-level button. Push and
hold the extend outrigger button. The outriggers
will lower and adjust to level the machine and
raise the wheels slightly off the ground.
15 Repeat the procedure for each outrigger.
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 33 34

Comments to this Manuals

No comments