Genie TMZ-10 User Manual download pdf (Page 19)

Part No. 72896 Genie TMZ-50/30 & Genie TMZ-17/10 17

Operator's Manual

First Edition • Third Printing

Function Tests

1 Be sure the boom hold-down latches are

unlatched.

Setup

2 Position the machine below the desired work

area.

3 Set the parking brake.

4 Insert the key and turn to ground control.

5 Pull out the red Emergency Stop buttons at the

ground and platform controls.

Models with optional drive system: Also pull out

the red Emergency Stop button on the drive

control panel.

Machines with LED diagnostic readout: LED

should read ----.

Note: Machines with LED diagnostic readout

perform a self-check when the power is turned on.

The self-check takes about 5 seconds. Do not

touch the buttons of the ground control panel until

the self-check is done.

6 Push and hold the auto-level button. Push and

hold the extend outrigger button. The outriggers

will lower and adjust to level the machine and

raise the wheels slightly off the ground. Level

the machine using only the outriggers. Do not

use chocks, blocks or shims of any kind to level

the machine.

Function Tests

Do Not Operate Unless:

You learn and practice the principles of safe

machine operation contained in this operator's

manual.

1 Avoid hazardous situations.

2 Always perform a pre-operation

inspection.

3 Always perform function tests prior to

use.

Know and understand the function tests

before going on to the next section.

4 Inspect the workplace.

5 Only use the machine as it was intended.

Fundamentals

The Function Tests are designed to discover any

malfunctions before the machine is put into

service. The operator must follow the step-by-step

instructions to test all machine functions.

A malfunctioning machine must never be used. If

malfunctions are discovered, the machine must be

tagged and removed from service. Repairs to the

machine may only be made by a qualified service

technician, according to the manufacturer's

specifications.

After repairs are completed, the operator must

perform a pre-operation inspection and function

tests again before putting the machine into service.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

Comments to this Manuals

No comments

Genie TMZ-10 User Manual Page 19

Comments to this Manuals