Genie INTELLIG 4024 User Manual download pdf (Page 8)

CONTACT REVERSE TEST

The Force and Limit settings on the previous page MUST be COMPLETED before Contact

Reverse testing.

1. Test.

• Open garage door using wall console.

– Place a 2" x 4" board (laid flat) under center of garage door opening.

• Close garage door using wall console.

• When door contacts board, the door must stop (within 2 seconds) and reverse direction

returning to open position.

2. Adjustment.

• If the door:

– Stops before it contacts the 2 x 4 board, it may simply be responding to an improperly set

down limit. Return to pages 6-7 and repeat steps 1 through 10 to correct down limit.

– Stops after contacting the 2 x 4 board and does not reverse it may need an adjustment to

the down limit. Return to pages 6-7 and repeat steps 1 through 10 to correct down limit.

• Test again. Repeat as necessary until door reverses upon contacting board.

WARNING

A moving door can cause serious injury or death.

1. Keep people clear of opening while door is moving.

2. Do NOT allow children to play with opener, including

wall console, remote, or wireless keypad.

3. During programming, door opener could begin to run,

so stay away from moving door and its parts.

On Wall Console

PRESS and RELEASE

DOOR OPENS

PRESS and RELEASE

Once the Contact Reverse Testing is complete continue with Programming Remotes on the next page.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

No comments

Genie INTELLIG 4024 User Manual Page 8