Genie INTELLIG 4024 User Manual download pdf (Page 15)

OVERVIEW - REMOTES AND OPTIONS

FCC and IC CERTIFIED

This device complies with FCC Part 15 and RSS

210 of Industry Canada. This equipment has been

tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the

FCC Rules. These limits are designed to provide

reasonable protection against harmful interference

in a residential installation. This equipment

generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance

with the instructions, may cause harmful

interference to radio communications. However,

there is no guarantee that interference will not

occur in a particular installation. If this equipment

does cause harmful interference to radio or

television reception, which may be determined

by turning the equipment OFF and ON, the user is

encouraged to try to correct the interference by

one or more of the following measures:

• Re-orient or relocate the receiver antenna.

• Increase the separation between the opener and

receiver.

• Connect the opener into an outlet on a circuit

different from that to which the receiver is

connected.

• Consult your local dealer.

FIG. 5-1 Remote

WARNING

A moving door can cause serious injury or death.

1. Keep people clear of opening while door is

moving.

2. Do NOT allow children to play with opener,

including wall console, remote, or wireless

keypad.

3. During programming, the door opener could

begin to run, so keep people and objects away

from the moving door and its parts. To keep the

door from moving, close the door and disconnect

it from the rail carriage by pulling the Emergency

Release Handle. See page 19 for Release Handle

operation.

Three Button

Remote

See page 21 for battery changing instructions.

LOST OR STOLEN REMOTE - CLEARING MEMORY

Clearing remotes from powerhead memory will

clear ALL programmed remotes and wireless

keypad.

NOTE: Follow the PROGRAM REMOTE TO

POWERHEAD steps to re-enter remaining or new

remotes. See page 9.

1. Press

PROGRAM

SET

and hold

until both lights

come ON BLUE.

Release button.

2. Lights go out and Round

BLUE light comes ON.

3. Press

PROGRAM

SET

again and

long LED flashes

PURPLE.

PROGRAM

SET

—

PROGRAM

SET

—

4. Press both and

simultaneously on the

powerhead and hold until

both LEDs flash BLUE.

• Verify memory is cleared. Press a remote

button that was previously programmed to

the powerhead. Remote will not activate door

opener.

• Garage door opener will operate normally using

wall console.

• Program remaining or new remotes as shown

on page 9. Your door opener will no longer

recognize any signal received from the missing

remote, or any other which has not been

reprogrammed to the powerhead.

OGRAM

SET

—

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Comments to this Manuals

No comments

Genie INTELLIG 4024 User Manual Page 15

Comments to this Manuals

Related products and manuals for Kitchen Genie INTELLIG 4024