Genie INTELLIG 3024 User Manual Page 9

  • Download
  • Add to my manuals
  • Print
  • Page
    / 26
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 8
©2010 The Genie Company 01/27/2010
9
PROGRAM
SET
+
5 SECS
PROGRAM
SET
+
PRESS and HOLD
SEE BOTH
Blue LEDs
come ON
SEE one
Blue LED
come ON
PRESS a previously programmed Genie®
IntelliCode® 2 remote button on remote. If you
are unsure which remote you have see page 15.
Remote must be IntelliCode® 2 enabled.
RELEASE
1 2 3 4
OPTIONAL PROGRAMMING POWER HEAD TO
Homelink®, Car2U®, or IntelliCode® 1 REMOTES and SERIES II WIRELESS KEYPADS
To complete any of these tasks you MUST have at least one Genie® IntelliCode® 2 remote button already
programmed to the power head.
Homelink® or Car2U®: You must also have your Homelink® or Car2U® enabled vehicle present and their
programming instructions to perform these programming steps.
Genie® remote: You must also have your Genie® IntelliCode® 1 remote present.
Genie® wireless keypad: You must also have your Genie® wireless keypad installed and a PIN already programmed into the keypad.
PRESS and
RELEASE
5
On the IntelliCode® 1 remote PRESS
a button and RELEASE.
6
SEE both LEDs flash Blue.
IntelliCode® 1 remote or wireless keypad programming
7
On the IntelliCode® 1 remote PRESS
the same button and RELEASE.
The next press of the remote will
operate door.
5
Enter your wireless keypad PIN.
6
Press and hold button
(3 seconds) on wireless keypad and
see on power head long LED come ON
Purple. (You may have to press
more than once.)
8
Test. Repeat as necessary for any
other IntelliCode® 1 remotes.
7
Press and hold button
(3 seconds) on wireless keypad again
and see on power head both LEDs
come ON Blue.
8
Wait 30 seconds and test operation.
Genie® IntelliCode® 1 remote Genie® IntelliCode® 1 wireless keypad
SEE long Purple
LED flashing
SEE both LEDs
flash Purple
All optional programming is complete. Your garage door opener is ready to use.
5
For Car2U® enabled vehicles follow the Car2U®
instructions.
6
Test. Repeat as necessary for any other Car2U®
enabled vehicle.
Homelink® or Car2U® programming
If your Homelink® has been previously programmed to an
Genie® opener begin with Step 5.
If your Homelink® has not yet been linked to a Genie®
opener then go to page 15 and change one remote button
from IntelliCode® 2 to IntelliCode® 1, then program that
button to the power head and repeat steps 1-4 then
continue with Homelink® steps 5-6.
5
6
PRESS the Homelink® button twice.
Test. Repeat as necessary for any other pre-
programmed Homelink® enabled vehicle.
Page view 8
1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 25 26

Comments to this Manuals

No comments