Genie INTELLIG 3024 User Manual download pdf (Page 18)

CARRIAGE ENGAGE/DISENGAGE

Use Release Handle to manually engage or

disengage Carriage.

RESET - OPEN/CLOSE TRAVEL LIMIT

Performing all ten (10) Limits/Force setting steps

(pages 6-7) erases previous Limits/Force settings.

NOTE: The opener will not close the door

automatically unless the Safe-T-Beam® System is

installed and Limits are programmed.

MOTION DETECTOR - OVERVIEW

(Not available on all models)

Power heads equipped with a motion detector

sensor provide additional security when

exiting or entering the garage area.

NOTE: Sensor positioning on the power head does not

provide motion monitoring above the power head.

OPERATION

• Motion detector sensor is always ON. There are NO

user controls or adjustments.

• Lights automatically turn ON when motion is

detected and will turn OFF after 4 minutes of no

motion.

• Motion detector sensor will not turn OFF lighting

turned ON at the wall

console.

• Lighting turned ON at the wall console will remain

ON until wall

console turns lighting OFF or opener

is used.

PROGRAM

—

Motion Detector Sensor

CONTACT REVERSE TEST

The Force and Limit settings MUST be

COMPLETED before testing.

1. Testing.

• Open garage door using wall console.

– Place a 2" x 4" board (laid flat) under center of

garage door opening (Fig. 6-2).

• Close garage door using wall console.

• When door contacts board, the door must

stop (within 2 seconds) and reverse direction

returning to open position.

2. Adjustment.

• If the door does not reverse.

– Check to see if door has "down" limit properly

set in the fully closed position. It should not

have reached its "close" limit before hitting

board. Reprogram close limit with door

completely closed.

– If the door STOPS but does not reverse, reset

your limits. Remove board. Return to pages

6-7 and repeat Limits settings to correct down

limit.

• Test again. Repeat as necessary until door

reverses upon contacting board.

FIG. 6-2 2 x 4 under center of door opening

NOTICE

F DOOR B COMES OBSTRUCTED

PULL DOWN ON HANDLE

TO RELEASE CARRIAGE:

1. Pull DOWN on handle and let go.

2. Verify RED block is showing.

3. Raise or lower door manually.

DOOR

PULL

TO ENGAGE CARRIAGE:

1. Pull DOWN on handle and let go.

2. Verify RED block is NO LONGER showing.

3. Raise or lower door using remote or wall console.

Release Handle

FIG. 6-3 Disengage Carriage

LOCKED

UNLOCKED

WHEN RED BLOCK IS SHOWING

CARRIAGE IS UNLOCKED

FIG. 6-4 Carriage

(Standing below rail looking up at

carriage)

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24 25 26

Comments to this Manuals

No comments

Genie INTELLIG 3024 User Manual Page 18

Comments to this Manuals

Related products and manuals for Kitchen Genie INTELLIG 3024