Includes INTELLICODE® 2 Remote Control. Safe-T-Beam® System must be installed to close door.For use only with residential sectional or one piece over
©2010 The Genie Company 12/201010PROGRAMSET—+PROGRAMSET—+PRESS and HOLDSEE BOTH Blue LEDs come ONSEE one Blue LED come ONPRESS and release a previou
Release HandlePoignée de déverrouillagePalanca de liberaciónPOWER HEADTÊTE DE PUISSANCECABEZA DE LA ENERGÍAPower CordCordon de secteurCable eléctricoD
©2010 The Genie Company 12/201012NOTICEIF DOOR BECOMES OBSTRUCTEDIPULL DOWN ON HANDLETYPICAL SECTIONAL DOOR INSTALLATION FOR HELP-1-800-35-GENIE O
©2010 The Genie Company 12/201013SECTIONAL DOORPORTE SECTIONELLEPUERTA SECCIONALONE PIECE DOORPORTE D’UNE PIÈCEPUERTA DE UNA SOLA PIEZAIF DOOR BE
©2010 The Genie Company 12/201014SETPROGRAMOpen TravelButtonROUNDLED Indicator (Light)FacingGarage DoorLONGLED Indicator (Light)CloseTravelButton OV
©2010 The Genie Company 12/201015 OVERVIEW - REMOTES AND OPTIONS 5FCC and IC CERTIFIEDThis device complies with FCC Part 15 and RSS 210 of Indus
©2010 The Genie Company 12/2010163. Press the same button twice to toggle IntelliCode® selection from IntelliCode® 2 to IntelliCode® 1.INTELLICODE®
©2010 The Genie Company 12/201017MAINTENANCE & TROUBLESHOOTING FOR HELP-1-800-35-GENIE OR WWW.GENIECOMPANY.COM6If you have any questions, pl
• With the door closed, pull release handle DOWN and let go to release door carriage assembly from drive system.• Raise door manually approximatel
NOTICEIF DOOR BECOMES OBSTRUCTEDPULL DOWN ON HANDLETO RELEASE CARRIAGE: 1. Pull handle DOWN then let go. 2. Manually move door until carriage re
©2010 The Genie Company 12/20102SAFETY INFORMATIONIMPORTANT SAFETY INSTRUCTIONSREAD AND FOLLOW ALL INSTRUCTIONS SAVE THESE INSTRUCTIONSCONVENTIONS U
©2010 The Genie Company 12/201020Independent Light Control ButtonControls door opener lights from inside garageSure-Lock™ Button– LOCK disables cont
CHAIN OR BELT - TENSION ADJUSTMENT WARNING • Observe all safety warning and precautions!• Disconnect power from opener and disconnect carriage in
©2010 The Genie Company 12/201022ADJUSTMENT GUIDE - SPEED SETTINGS FOR HELP-1-800-35-GENIE OR WWW.GENIECOMPANY.COMSpeed settings are pre-programmed
©2010 The Genie Company 12/201023ADJUSTMENT GUIDE - FORCE SETTINGS FOR HELP-1-800-35-GENIE OR WWW.GENIECOMPANY.COMForce settings are pre-program
PROBLEM WHAT TO DOOpener does NOT run from wall console.• Check power source,– Plug a lamp into outlet used for powerhead. If lamp works, power sou
PROBLEM WHAT TO DONoisy operation.• Be sure all door fasteners are tight.• Be sure garage door is in good repair, properly lubricated and balanced.•
©2010 The Genie Company 12/201026REFERENCE - CIRCUIT WIRING DIAGRAM FOR HELP-1-800-35-GENIE OR WWW.GENIECOMPANY.COMRÉFÉRENCE - DIAGRAMME DE CÂBLAGE
GMI Holdings, Inc. d/b/a The Genie Company ("Seller") warrants to the original purchaser of the below identified garage door opener, Intelli
SAFETY FEATURESSafe-T-Beam® (STB) Non-Contact Reversing SystemPuts an invisible beam across the door opening. The door stops and reverses to the full
TABLE OF CONTENTSSection ...PageSafety Information ...
Begin here after the opener's physical assembly and installation has been completed. There are no assembly or installation steps included in thi
WARNING• Make sure doorway is in view and clear of obstacles and people to avoid injury or damage to property.• DO NOT operate this unit from wall c
©2010 The Genie Company 12/20107PROGRAMSET—SEE long Blue LED flashing6Watch door moveRAMSET—+B) OPEN DOOR TRAVEL LIMITNOTICEIF DOOR BECOMES OBSTR
©2010 The Genie Company 12/201081234CONTACT REVERSE TESTThe Force and Limit settings on the previous page MUST be COMPLETED before Contact Reverse t
©2010 The Genie Company 12/20109PROGRAMSET—+PROGRAMSET—+PROGRAM INTELLICODE® 2 REMOTE TO POWERHEAD FOR HELP-1-800-35-GENIE OR WWW.GENIECOMPANY.C
Comments to this Manuals