Genie DirectLift 3060 User Manual download pdf (Page 10)

For Help, call 1-800-35-GENIE or visit www.geniecompany.com

A Monthly:

• Door springs and door hardware:

– Oil door roller, bearings, and hinges using silicone

lubricant or light oil.

• Balance Door.

– Close door.

–

Release Carriage Assembly from Rail Assembly by pulling

the Emergency Release Knob towards the door.

– Raise door manually 3’- 4’ and verify that door stays at

that position. See Check Step 2 on page 4.

– Reattach Carriage Assembly to Rail Assembly:

Pull the Emergency Release Knob toward

Power Head.

b. Close door.

• Contact Reverse Test.

– Perform Adjustment 2 on page 8.

NOTE

When the door is 3’ - 4’ above the ground, the door

should stay open. Slight movement is acceptable. If

the door moves too much, contact a Genie Factory

Authorized Dealer for service or call Customer Service at

1-800-35-GENIE.

WARNING:

Do not operate door automatically or manually if springs

are broken. Contact a Genie Factory Authorized Dealer for

service or call Customer Service at 1-800-35-GENIE.

If the door fails to reverse on contact with the board,

adjust the Close Force Control as specified in Set Limit

Switches and Force Controls on page 7 & 8. If the Opener

still fails, contact a Genie Factory Authorized Dealer for

service or call Customer Service at 1-800-35-GENIE.

NOTE

Use ONLY Genie Lubricant (GLU-3). Other lubricants

may damage the Opener.

FCC AND IC CERTIFIED

All devices comply with Part 15 of the FCC Rules.

Operation is subject to the following two conditions: (1)

this device may not cause harmful interference, and (2)

this device must accept any interference received, includ-

ing interference that may cause undesired operation.



GLU-3

Lubricant

MAINTENANCE

B Yearly:

• Wipe off old excess lubricant from Drive Screw.

• Lubricate Drive Screw with Genie Lubricant (GLU-3)

C As needed

• Replace lightbulbs. (See page 9)

Safe-T-Beam® System Self-Diagnostic Troubleshooting

Source (Red LED) Sensor (Green LED) Possible Problem Solution

ON ON Normal operation None required

OFF OFF

• Power Head not powered • Check breakers, fuses, plugs

• Wiring from Power Head bad • Check wiring for obvious shorts

OFF ON

• Wiring to Source missing or bad • Check wiring

• Power has been interrupted • Remove power and reapply

2 BLINKS, Pause • Beam not aligned • Check Source, Sensor alignment

(Repeat) ON • Beam obstructed • Check for obstruction

• Sensor defective • Contact Customer Service

2 BLINKS, Pause • Wire to Sensor missing or bad • Check wiring

(Repeat)

OFF

• Sensor defective • Contact Customer Service

3 BLINKS, Pause • Sensor receiving interference • Determine source of interference

(Repeat)

• Check for interference from sun-

light or a source unit on an

adjacent door

• Contact Customer Service

4 BLINKS, Pause • Source not sending pulses • Contact Customer Service

(Repeat)

• Source defective • Contact Customer Service

TROUBLESHOOTING

WARNING:

1 2 ... 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Genie DirectLift 3060 User Manual Page 10

Comments to this Manuals

Related products and manuals for Kitchen Genie DirectLift 3060