Genie 1042 User Manual download pdf (Page 16)

PN# 3642036534, 02/26/2010 REV. 1

3.Securely fasten wires.

• Securely fasten wires to ceiling and

wall using insulated staples provided.

– Use insulated staples.

– Staples should be snug only.

• If rear cover is attached to power head,

remove it.

• On power head:

– Route wall button wires through wire guide on

power head.

– Split and strip ends of wire (Fig. 3-2 on

previous page).

– Insert wire into terminal holes and lightly press in

the orange locking clips above each terminal

hole. (You can use a pencil or small screwdriver

to comfortably press in locking clips.) The white

wire into #1 terminal hole and striped wire into

the #2 terminal hole.

– Confirm wire lock by lightly tugging on the wire.

The wire should remain in the terminal hole.

• Do NOT install rear cover yet.

4. Mounting.

• Fasten wall button to wall with 2 screws

(provided) (Fig. 3-4).

• Remove protective backing from "Entrapment"

warning label (Fig. 3-5). The "Entrapment" label

is located in the center of this manual.

– Stick label on wall near wall button.

FIG. 3-4 Mounting wall button.

Insulated

Staple

+–

Infrared Sensor

123456

FIG. 3-3 Insert wires

(Power Head With Rear Cover Removed)

1234

Terminal

Holes

Locking

Clips

FIG. 3-5 Mounting Entrapment warning label.

wire guide

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 67 68

Comments to this Manuals

No comments

Genie 1042 User Manual Page 16

Comments to this Manuals

Related products and manuals for Kitchen Genie 1042