Genie GS-2668 DC User Manual download pdf (Page 18)

16 Genie GS-2668 DC and Genie GS-3268 DC Part No. 82750

Operator's Manual Third Edition • Third Printing

FUNCTION TESTS

10 Push and hold the function enable button and

activate the platform down function.

Result: The platform should lower. The descent

alarm should sound while the platform is

lowering.

Test the Auxiliary Lowering

To test machines equipped with a

separate auxiliary lowering button

next to the ground control panel,

perform steps 11 through 13. For

machines that are not equipped with

a separate button, skip to step 14.

11 Push and hold the function enable button and

activate the platform up function. Raise the

platform approximately 2 feet / 60 cm.

12 Push and hold the auxiliary lowering button.

Result: The platform should lower. The descent

alarm will not sound.

13 Turn the key switch to platform control and go to

step 17.

Machines not equipped with a separate auxiliary

lowering button:

14 Push and hold the function enable button and

activate the platform up function. Raise the

platform approximately 2 feet / 60 cm.

15 Push and hold the function enable button.

Activate the down function.

Result: The platform should lower. The descent

alarm will not sound.

16 Turn the key switch to platform control.

1 Select a test area that is firm, level and free of

obstruction.

2 Be sure the battery pack is connected.

At the Ground Controls

3 Pull out the platform and ground red Emergency

Stop buttons to the on position.

4 Turn the key switch to ground control.

5 Observe the diagnostic LED

readout.

Result: The LED should look like the

picture at right.

Test the Emergency Stop

6 Push in the ground red Emergency Stop button

to the off position.

Result: No functions should operate.

7 Pull out the red Emergency Stop button to

the on position.

Test the Up/Down Functions

The descent alarm and the motion alarm sound at

60 beeps per minute and sound at the chassis. The

alarm that goes off when the machine is not level

sounds at 180 beeps per minute and sounds at the

chassis and in the platform.

8 Do not hold the function enable

button. Activate the platform up

function.

Result: No function should operate.

9 Push and hold the function enable button and

activate the platform up function.

Result: The platform should raise.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 35 36

Comments to this Manuals

No comments

Genie GS-2668 DC User Manual Page 18

Comments to this Manuals