Genie TML-4000N User Manual download pdf (Page 19)

Operator's ManualThird Edition • Second Printing

Part No. 97600 Genie TML-4000 and TML-4000N 17

Operating Instructions

Do Not Operate Unless:

You learn and practice the principles of safe

machine operation contained in this operator's

manual.

1 Avoid hazardous situations.

2 Always perform a pre-operation inspection.

3 Always perform function tests prior to use.

4 Inspect the workplace.

5 Only use the machine as it was intended.

Fundamentals

The Operating Instructions section provides

instructions for each aspect of machine operation.

It is the operator's responsibility to follow all the

safety rules and instructions in the operator's,

safety and responsibilities manuals.

If more than one operator is expected to use a

machine at different times in the same work shift,

each operator is expected to follow all safety rules

and instructions in the operator's manual. That

means every new operator should perform a pre-

operation inspection, function tests and a work

place inspection before using the machine.

Setup

Make sure the machine is set up according to the

Setup procedure in the Function Tests section.

Starting the Engine

1 Make sure the circuit breaker light switches are

in the off position.

2 At the control panel, turn the key or turn the

switch to the run position. The glow plug light

will come on.

3 Wait for the glow plug light to go off.

4 Turn the key or turn the switch to start.

Note: If the key or switch is not turned to start

within 10 seconds of the glow plug light going off,

the engine may fail to start. If this happens, turn

the key or switch to the off position and repeat the

procedure.

Note: If the glow plug light is flashing during the

preheat cycle, the battery is low.

Operation of Lights

1 Turn on the lights using the circuit breaker

switches located on the control panel. Each

switch corresponds to one of the lamps.

Note: The lights can take up to 20 minutes to reach

full intensity.

Note: If the lights are turned off and turned back on

while they are still warm, they will not light up again

for 20-30 minutes.

2 Turn the lights off by turning the circuit breaker

switches to the off position. Make sure the

lights are turned off before shutting down the

engine.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Comments to this Manuals

No comments

Genie TML-4000N User Manual Page 19

Comments to this Manuals