Genie TML-4000N User Manual download pdf (Page 16)

14 Genie TML-4000 and TML-4000N Part No. 97600

Operator's Manual Third Edition • Second Printing

FUNCTION TESTS

Setup

1 Position the machine at the desired work site.

2 Disconnect the trailer lights and safety chains.

3 Open the latch on the coupler.

4 Pull the release pin on the tongue outrigger and

rotate the outrigger towards the ground until the

outrigger pin locks securely in place.

5 Turn the jack handle to lower the outrigger foot

pad and raise the tongue of the machine

enough to clear the tow vehicle.

6 Release the spring pin on the side outriggers

and lower them to the ground. Make sure the

locking arms are locked in place.

7 Turn the outrigger jack handles to level the

machine. Level the machine using only the

leveling jacks.

Install the Lamp Fixtures (if

applicable)

For each lamp fixture:

8 Remove the lamp fixture from the storage

location under the covers.

9 Slide the fixture into the holes on the mounting

bracket and close the latches.

10 Insert and close the safety pins.

11 Remove the cap from the receptacle socket and

connect the electrical plug.

Note: Make sure the safety pins are properly

installed before raising the mast.

Test the Machine Functions

By raising and extending, then retracting and

lowering the mast back to the horizontal position,

the following functions will be tested: winches,

latches, mast extension and mast rotation.

12 Unlock the mast hold-down latch.

13 Turn the raise/lower winch handle clockwise until

the mast raises approximately 2 feet /

60 cm.

Result: A clicking sound should be heard as the

winch handle is turned.

14 Release the winch handle.

Result: The winch brake should hold when the

handle is released.

15 Continue to turn the winch handle clockwise

until the mast reaches full vertical position.

Result: The mast should raise smoothly, free of

hesitation or binding.

Result: The spring latch on the front of the

machine should lock the mast securely into

place.

16 Turn the extend/retract winch handle clockwise

until the mast extends approximately 2 feet /

60 cm.

Result: A clicking sound should be heard as the

winch handle is turned.

Result: The mast sections should telescope

smoothly, free of hesitation or binding.

17 Release the winch handle.

Result: The winch brake should hold when the

handle is released.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

Genie TML-4000N User Manual Page 16

Comments to this Manuals