Genie M-4700 User Manual download pdf (Page 9)

■ Mark pilot holes location on header through holes where

lag screws will be inserted. IMPORTANT: See Fig. 11 for

which header bracket holes to use.

■ Drill 3/16" pilot holes into header, and install bracket with

lag screws (5/16 x 1-5/8”) provided.

■ Tighten lag screws firmly.

NOTE: Follow the same procedure if header (shown in Fig.

11) runs vertically instead of horizontally and is the only

option for mounting header bracket to header wall. In case

of minimal clearance above the garage door, the header

bracket may be mounted to the ceiling. Follow the same

steps above to ensure a sound surface for mounting.

A. FOR SECTIONAL DOORS:

Wood Sectional Doors (Fig. 14)

■ Position door bracket (Fig. 13) along vertical center line of

door with pin hole facing top of the door and top edge of

the bracket 4” to 5” below top edge of the door, or

roughly at the same height as top rollers on the door.

■ Mark locations of securement holes through door bracket.

■ Drill two 1/4" holes through door for securement of

door bracket.

■ Insert carriage bolts (1/4” x 2”) from the outside through

door and bracket, then secure with lock washers and nuts

from the inside.

■ Tighten nuts firmly.

B. FOR ONE-PIECE DOORS:

Before starting the installation of the door bracket, cut off

mounting leg from opposite side of pin hole.

One-Piece Doors with Exposed Frames (Fig. 15)

■ Position center of door bracket on the center line on the

top edge of door.

■ Mark the position where carriage bolts will go through

bracket, and drill two 1/4" holes through top frame of

door.

■ Install carriage bolts from the bottom, through door

frame and bracket, and secure with lock washer and nut

from top.

■ Tighten nuts firmly.

8-3. INSTALL DOOR BRACKET TO DOOR

8-2. INSTALL HEADER BRACKET (cont’d)

Pilot Hole

Ceiling

Header Bracket

Lag Screw

Fig. 12

One-Piece Doors without Exposed Frames (Fig. 16)

■ For doors without exposed frames, use alternate method

of mounting door bracket.

■ Mark and drill two 3/16" pilot holes into top of frame,

then secure bracket with 5/16" x 1-5/8" lag screws

(not provided).

Insert 1/4-20 x 2”

Carriage Bolts

from outside of door

Door Bracket

Lock Washer

Wood Sectional

Doors

1/4-20 Nut

Garage Door

Center Line

Carriage Bolts

Garage Door

Center Line

Lag Screws

One-Piece Door

with Exposed Frame:

Install with Carriage Bolts

One-Piece Door

without Exposed Frame:

Install with Lag Screws (not provided)

Fig. 13

Fig. 14

Fig. 15 Fig. 16

cut off for one-piece

door only

Pin Hole

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

Genie M-4700 User Manual Page 9

Comments to this Manuals

Related products and manuals for Garage Door Opener Genie M-4700