Genie M-4700 User Manual download pdf (Page 18)

The control panel is located under the control panel cover.

Open the control panel by slightly pulling on the cover

cutout, then allowing the cover to drop open. The hinges

enable the cover to remain in place while you set

the adjustments.

On control panel you will find 3 buttons labeled “P”, “+”,

and “–” which allows you to set all the adjustments of your

opener and a circular LED display with 8 numbered icons

which shows useful status information regarding the opener

and its function. See Fig. 38, 38A.

LEDs #1, #3, and #5 are used when setting the adjustments

or for troubleshooting, should a problem ever occur with

your opener. See section “8-18. Setting The Adjustments” on

p. 18, and section 18. Troubleshooting” on p. 29 for more

information.

NOTE: When viewing control panel and setting the adjust-

ments, stand below the opener and face the garage door.

Then look up at the display. This way you will easily be able

to see both the display and the door.

Any adjustment can be made at any time using these 3

buttons: “+“, “–”, and “P”. However, it is easiest during

initial installation to follow the order shown below. Before

beginning, install battery in your transmitter.

See Fig. 47, p. 22.

The adjustments that can be made are: Open Travel Limit,

Close Travel Limit, Maximum Opening Force, Maximum

Closing Force, and Transmitter Programming.

HANDY NOTE: If you follow the following steps, you will

notice that when making the adjustments, and if no changes

are needed at any particular stage, you can keep the current

information and ”skip“ over a specific adjustment by

pressing the “P” button once. This is useful to know if you

want to change only one setting, without changing any of

the other adjustments. Simply enter the adjustment mode

by pressing and holding the “P” button for approximately

2 seconds, then press and release “P” repeatedly until your

particular adjustment is reached. This bypasses the unneeded

adjustments, and takes you right to the adjustment you

want. When your adjustment or setting is complete, simply

press “P” as many times as needed to bypass the remaining

steps and exit out of the program, returning the opener to

normal mode.

TO MAKE OR CHANGE ANY ADJUSTMENT:

Press and hold the “P” button for approximately 2 seconds.

When all LEDs illuminate and LED #2 begins to blink, release

the button. You are now ready to set or change the desired

adjustment.

8-18. SET THE ADJUSTMENTS

8-17. CONTROL PANEL

Rail

Control Panel

Opener Power

Head

Control Panel

Cover

Cutout

Hinges

Fig. 37

Fig. 38A

LED #2 ■ Lights up when door is in

fully opened position.

LED #4 ■ Lights up when door is in

fully closed position.

LED #6 ■ Flashes when obstruction is

detected, door reverses, or

Comments to this Manuals

No comments

Genie M-4700 User Manual Page 18

Comments to this Manuals

Related products and manuals for Garage Door Opener Genie M-4700