Genie 1500 User Manual download pdf (Page 10)

ROUTINE YEARLY

Lubricate the drive screw:

s Wipe off old grease using a lint-free cloth.

s Apply a light coating of silicon based grease

(For best results, use Genie® GLU-R).

9

©2011 The Genie Company

9/2011

CORRECTIVE MAINTENANCE

TO ENGAGE, PULL

DOWN AND TOWARD

THE OPENER. THEN LET GO.

TO DISENGAGE, PULL

DOWN ON THE RELEASE

HANDLE AND LET GO.

DISENGAGING AND ENGAGING CARRIAGE

CHANGE LIGHT BULBS

WARNING

s When replacing light cover, make sure wires are

not pinched or near moving parts.

s Use extreme caution when working from a ladder

or step stool.

1. Disconnect power to door opener.

s/PENPowerhead light cover.

s2EMove light bulb(s).

s2EPLAce light bulb(s).

– Do NOT use light bulbs with greater than

100 Watt rating.

s#LOSEPowerhead light cover.

2. Reconnect power to door opener.

s Test light operation.

RESET - OPEN/CLOSE TRAVEL LIMIT

Performing all ten (10) Limits/Force setting steps

(page 5) erases previous Limits/Force settings.

NOTE: The opener will not close the door

automatically unless the Safe-T-Beam® System is

installed and Limits are programmed.

REMOTE BATTERY REPLACEMENT

Replace remote battery with a

CR 2032 coin cell battery.

1. Open the remote case using a

washer or coin that fits into the

slot at the top of the remote.

2. Replace battery.

3. Align components and

snap case closed.

ENGAGED

DISENGAGED

OPENER

1 2 ... 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments