Genie Z-34 User Manual download pdf (Page 21)

Part No. 56011 Genie Z-34/22 Bi-Energy 19

Operator's Manual

First Edition • Fifth Printing

Operating Instructions

Introduction

This machine can be operated with or without the

engine running.

Starting the Engine

1 At the ground controls, turn the key switch to

the desired position.

2 Be sure both ground and platform control red

Emergency Stop buttons are pulled out to the

on position.

3 Move the engine start toggle switch to either

side. If the engine fails to start or dies, the

restart delay will disable the start switch for

3 seconds.

If the engine fails to start after 15 seconds of

cranking, determine the cause and repair any

malfunction. Wait 60 seconds before trying to start

again.

In cold conditions, hold the glow plug switch to

either side and then start the engine.

In extreme cold conditions, 20°F / -6°C and below,

hold the glow plug switch to either side for 10

seconds and then start the engine. Warm the

engine (use low idle) for 5 minutes to prevent

hydraulic system damage.

Do Not Operate Unless:

You learn and practice the principles of safe

machine operation contained in this operator's

manual.

1 Avoid hazardous situations.

2 Always perform a pre-operation

inspection.

3 Always perform function tests prior to use.

4 Inspect the workplace.

5 Only use the machine as it was intended.

Fundamentals

The Operating Instructions section provides

instructions for each aspect of machine operation.

It is the operator's responsibility to follow all the

safety rules and instructions in the operator's,

safety and responsibilities manuals.

Using the machine for anything other than lifting

personnel and tools to an aerial work site is unsafe

and dangerous.

Only trained and authorized personnel should be

permitted to operate a machine. If more than one

operator is expected to use a machine at different

times in the same work shift, they must all be

qualified operators and are all expected to follow all

safety rules and instructions in the operator's,

safety and responsibilities manuals. That means

every new operator should perform a pre-operation

inspection, function tests, and a workplace

inspection before using the machine.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 30 31

Comments to this Manuals

No comments

Genie Z-34 User Manual Page 21

Comments to this Manuals

Related products and manuals for For the car Genie Z-34