Genie Z-25J User Manual download pdf (Page 43)

Operator's ManualFourth Edition · First Printing

Part No. 114339 Z-45/25 • Z-45/25J 41

Operating Instructions

Starting the Engine

1 At the ground controls, turn the key switch to

the desired position.

2 Be sure both ground and platform control red

Emergency Stop buttons are pulled out to the

on position.

Gasoline/LPG models

3 Choose fuel by moving the fuel select switch to

the desired position.

4 Move the engine start toggle switch

to either side. If the engine fails to

start or dies, the restart delay will

disable the start switch for 3

seconds.

Diesel models

3 Move the glow plug switch to either side and

hold for 3 to 5 seconds.

4 Move the engine start toggle switch to either

side. If the engine fails to start or dies, the

restart delay will disable the start switch for 3

seconds.

All models

If engine fails to start after 15 seconds of cranking,

determine the cause and repair any malfunction.

Wait 60 seconds before trying to start again.

In cold conditions, 20°F / -6°C and below, warm the

engine for 5 minutes before operating to prevent

hydraulic system damage.

In extreme cold conditions, 0°F / -18°C and below,

machines should be equipped with optional cold

start kits. Attempting to start the engine when

temperatures are below 0°F / -18°C may require the

use of a booster battery.

Gasoline/LPG models: In cold conditions, 20°F /

-6°C and below, the machine should be started on

gasoline and warmed for 2 minutes, then switched

to LPG. Warm engines can be started on LPG.

Emergency Stop

Push in either ground or platform red Emergency

Stop button to the off position to stop all functions

and turn the engine off.

Repair any function that operates when the red

Emergency Stop button is pushed in.

Selecting and operating the ground controls will

override the platform red Emergency Stop button.

Auxiliary Controls

Use auxiliary power if the primary power source

(engine) fails.

1 Turn the key switch to ground or platform

control.

2 Pull out the red Emergency Stop button to the

on position.

3 Press down the foot switch when operating the

auxiliary controls from the platform.

4 Simultaneously hold auxiliary

power switch on and activate the

desired function.

The drive and steer functions will not operate with

auxiliary power.

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 58 59

Comments to this Manuals

No comments

Genie Z-25J User Manual Page 43

Comments to this Manuals